QuailRiver
fully equipped rock polisher
Member since May 2008
Posts: 1,634
|
Post by QuailRiver on Jun 23, 2015 0:18:21 GMT -5
This past weekend I ran across my old packing slip for the best deal I could find at the time for the last replacement 4rpm powerfeed motor I bought. This motor can be used with the Lortone 10", 12", 14" and Raytech 10" saws. I had to trim down the shaft length a little but that was easy to do. Since these replacement motors come up as a topic from time to time here I thought I would post a link to the last one I bought which I used to slow down the powerfeed speed on my Lortone 14" Panther. The factory powerfeed motor on my Lortone 14" saw fed at 17" per hour and was too fast for the harder agates I was cutting so I replaced it with the same speed as their 10" and 12" saws use. I purchased this motor from Zoro Tools. Zoro item number G0509467 and it is a Dayton motor, Dayton number 3M098. And if you buy it through Zoro's eBay store they offer free shipping. Here is the link to the motor on Zoro's web site in case you would like to bookmark it just in case you ever need a replacement. www.zoro.com/dayton-ac-gearmotor-4-rpm-open-115v-3m098/i/G0509467/Larry C.
|
|
|
Post by Rockoonz on Jun 23, 2015 0:48:47 GMT -5
I bought one from them for an old kit built saw I overhauled for the rock club.
|
|
QuailRiver
fully equipped rock polisher
Member since May 2008
Posts: 1,634
|
Post by QuailRiver on Jun 23, 2015 1:01:15 GMT -5
I bought one from them for an old kit built saw I overhauled for the rock club. I've ordered from Zoro Tools two or three times and have always gotten good service from them. And they frequently issue savings coupons too if you sign up for their emails. Larry C.
|
|