Getta Grip
noticing nice landscape pebbles
Member since November 2016
Posts: 81
|
Post by Getta Grip on May 18, 2017 16:47:07 GMT -5
Greetings Everyone,
I am restoring an old HP B-12 grinder. The buffing wheel and shroud (right hand side) are missing.
I'm trying to decide if I will put one or two Expando wheels on that end of the shaft or should I put a leather polishing wheel back on there.
Here's one concern. My shaft is going to be spinning 1740 RPM. That's pretty fast for a polishing wheel.
I have a 12" leather bull wheel I can put on there but I'm not convinced that's the best use of the space.
I would appreciate any thoughts you may have on this.
Currently I have the following wheels.
180 gt.... Red/brown Cratex rubber 120gt (Acts like a 360 gt) ..... 600 gt ..... 1200 gt.
I have a separate 12" leather bull wheel unit that I can use for polishing. I also have just a 12" wheel (sanding disk from a Shopsmith) that I can easily turn into a bull wheel.
|
|